[BUG?] Set input image to artmesh gives different output?

Ran_TH

I noticed a new menu was added to Source Image tree in Project Panel about "Set as input image to selected artmesh"
Which is a welcome change since I used that function a lot and I don't have to go through long list of Model Guide image tree!

However I noticed a slightly different behavior between the same menu in Source Image and Model Guide Image tree.

First I made a copy of an artmesh


Then I apply the 'Set input image' from Model Guide Image tree menu to the new copied artmesh, which will update the target mesh as expected.


However if I do that through the menu in Source Image tree, it updates both of copied artmesh and original artmesh.


Is this an expected behavior or is it a bug?

I am using Live2D version 4.1.05beta1.

Thank you,

ueno(staff)

Hello, @Ran_TH .
Thank you for your contact.
This is Live2D Support.

These are two different functions with different names.

Source Image: “Set as input image for the modelimage of selected ArtMesh”
Replaces the layer image referenced by the modelimage associated with the selected ArtMesh.

Model Guide Image: “Set as input image for selected ArtMesh”
Replaces the image referenced by the selected ArtMesh.

Please refer to the following page for Source Image and Model Guide Image.
https://docs.live2d.com/cubism-editor-manual/original-picture/?locale=en_us

Please use differently depending on your purpose.
Thank you for your cooperation.

Ran_TH

Okay thank you for clarifying!